• Home
  • About
  • Contact
  • FEATURES
  • The Board Layout
  • Technical Specification
  • Store
Picture

The INWE 4 Door Controller

The Controller is a versatile Four Door Networked board, it has been designed with the benefit of working directly with access control installers.

The aim of the controller is to offer a flexible premium controller, whilst offering simple connectivity and networking.

Coastform are committed to help installers with their installations and offer on line and telephone support.

The controller has a number of inbuilt monitors, which will offer protection to the individual door controls, in the event of an output short - a fault on 1 door will not disable the other doors

This controller will be evolved, in the future, to include Blue Tooth management. Whilst this will not offer all the features of a PC managed system, it will allow management of the system from a smart phone or tablet

The Board

The board has 4 identical Door Controls, one on the top, one on the bottom and one on each side
Picture
;lk;
The individual door controllers can be though of as comprising three distinct areas
  1. Inputs -Exit Switch, Door Contact and 1 user defined input 
  2. Reader - INWE reader for the 3 wire INWE reader or 7 wires which will allow most Wiegand or Clock& Data readers to be connected - the colour of the cores that individual manufacturers use can vary, the core function is identified.
  3. Output - The board voltage will define the lock output as 24V or 12V                                                          The Lock + and Lock -, should be used for all fail safe and fail secure locks, the software is used to define the output type                                                                                                                                                       The lock +/- output, has built in protection against back emf and does not require a diode at the lock                                                                                                                                                                 The Relay output can be utilised for external supplies or as a volt free contact.
On the left hand side of the board, above door 4 controls there is the input voltage supply, this is designed for 12V & 24V DC supplies, there is also an input for Tamper

On the right hand side of the board, above the "door 2" controls, the 3 wire 485 network connections are shown, there are also switches for end of line resistors
Proudly powered by Weebly
  • Home
  • About
  • Contact
  • FEATURES
  • The Board Layout
  • Technical Specification
  • Store